Neat D-SERVER Technical Handbook page 59

System parameter
serial-port-name
serial-port-name
simple-paging-send-time-sec
status-message-retry-timeout-
sec
status-message-send-interval-
sec
system-id
table-page-size-in-web
use-utf8-bom-in-log-files
NE41 09010-02 v3.0
Description
Do not change this parameter!
Determines the name of the serial port devices.
There must be two entries for this parameter:
Entry with value "/dev/ttyS1"
Entry with value "/dev/ttyS2"
Do not change this parameter!
Determines the name of the serial port devices.
There must be two entries for this parameter:
Entry with value "/dev/ttyS1"
Entry with value "/dev/ttyS2"
Used for ESPA paging. 300 means how long the
system will try to page all devices before timeout. If
all devices replies, paging is stopped.
Parameter control the timing of status changes for
alarm receivers.
Status change requests from alarm receivers.
This parameter determines how long new status
change requests (with the same status) will be
seen as duplicates of the same message. A new
reply will be sent, but the "elapsed-timein-busy-
mode" will not be reset.
Status change messages sent by the D-SERVER
The messages are sent because an alarm receiver
has been too long in busy mode. This parameter
determines how long the D-SERVER will keep send-
ing the same status change message if no reply is
received from the alarm receiver. The parameter
"status-message-send-intervalsec" determines
how often the message is re-transmitted.
Parameter control the timing of status changes for
alarm receivers.
Determines how often a status change message
(receiver "Busy" or receiver "Idle") is re-transmit-
ted by the D-SERVER if there is no reply from the
alarm receiver. This applies only when an alarm
receiver has been too long in "Busy" mode.
The identification number for the D-SERVER sys-
tem.
The system-id value for the D-SERVER must be the
same in all D-TREXes in the system.
If there are several D-SERVER systems within range
of each other, they must all have different
system-id values.
Parameter control the appearance of tables in the
D-SERVER web page.
Determines the number of rows that are shown on
each page for tables.
Controls if the UTF8 BOM should be added in the log
files.
Default value
/dev/ttyS1
/dev/ttyS2
300
60
3
1
50
1
D-SERVER Technical Handbook
neat
59