Neat D-SERVER Technical Handbook page 54

neat
54
D-SERVER Technical Handbook
System parameter
configuration-disable-ack-
timeout
configuration-job-timeout-
dserver
configuration-job-timeout-
dtect
dcall-allow-alarm-override
debug-alarm-list
debug-alarm-receivers
debug-changed-messages
debug-cobs-transmission
debug-config
debug-configure-job
debug-door-opening
debug-dtect
debug-dtrex-presence-list
debug-email-log
debug-espa-4.4.4-alarm-
reception
debug-ignored-messages
debug-ip-transmission
debug-logging-enabled
debug-network-log
debug-paging
debug-radio-send-queue
debug-radio-transmission
debug-retransmit-unknown
debug-router
debug-serial-bus
Description
Tells the transceiver units in the system how long
they should ignore ACK from a certain device.
Normally, ACK is restored to normal operation after
a config job has been completed.
How long before the dserver app should cancel the
current D-ATOM/SMILE config job.
How long before the transceiver unit doing the con-
figuration should cancel the current config job.
If a D-CALL should be able to handle a new alarm
before the current alarm is finished.
Supported in Application v1.19.00 and forward.
Low level logging of alarm reception and alarm
cancellation.
Logging for alarm receivers.
Logging for the changed messages. When a
personnel does presence against for example a
D-ATOM, further alarms from that D-ATOM will be
changed to an assistance alarm.
Logging for COBS transmissions. Level 2 will log
XML data as well.
Logging of system parameters.
Logging of a D-ATOM/SMILE configuration job.
Logging of door openings.
Logging of D-TECT units.
Logging of D-TREX presence indications.
Logging of e-mail logging.
Logging of ESPA communication.
Logging of ignored radio messages.
Logging of IP transmissions to D-CALL/D-TECT IP.
Parameter enable debug-logging.
"0" = logging is disabled
"1" = logging is enabled
Logging of logmessages sent over Ethernet.
Logging of paging sequences.
Logging of the queues for transmission of radio
messages.
Logging of radio transmission messages.
Logging of the re-transmission of unknown radio
messages, see system parameter:
retransmitunknown-send-count.
Logging of the router task.
Logging of communication on the serial bus.
If the debug logging for the serial bus is enabled
(debug-serial-bus changed to other value
than zero (o)), the memory card in the D-SERVER
can fill up very quickly. After that, all logging will
stop working.
Default value
600
180
120
0
0
1
0
0
0
0
0
1
0
0
0
0
1
0
1
1
0
1
0
1
0
NE41 09010-02 v3.0