Epson TM-T88 Series Technical Reference Manual page 97

Pattern C
Autocutting is performed at the specified paper cut position. However, when the label length is shorter
than 35 mm {1.38"}, the printer feeds the paper to the point where the label length is 35 mm {1.38"}, and
then performs autocutting.
Top margin =14 mm {0.55"}
Bottom margin = User-defined value
When the printer has the next print data, including data that
can be printed immediately after autocutting, the printer
cuts the paper at the position specified by the user-defined
value.
When the label is shorter than 35 mm {1.38"} long, the
printer feeds the paper so that the label is 35-mm {1.38"}
long minimum, and performs autocutting.
When auto top margin scaling is enabled, the top margin is
reduced automatically.
Bottom margin = User-defined value + 0 to 25.4 mm {0 to 1"}
* If the stop position for autocutting is set to a specific
position, the printer feeds the paper to the cut position and
performs autocutting.
*If the stop position for autocutting is set to an arbitrary stop
position, the printer performs autocutting at the position
specified by the user-defined value.
Top margin = 14 mm {0.55"}
Print on the first label
Print on the second
label
Print on the third
label
Print on the first label
(Next sheet)
Print on the second
label (Next sheet)
Print on the third
label (Next sheet)
Appendix
When the printer receives
print data for 3 labels
continuously
Position where autocutting
is set
Actual autocut position
*When the stop position for
autocutting is set to a
specific stop position
When the printer receives
print data for 3 labels again
97