Epson TM-T88 Series Technical Reference Manual page 95

Pattern A
Top margin of next label
Paper removal standby
SW setting
Stop position for cutting
Paper
Auto top margin scaling
Liner-free label
paper
MSW6-1 Cut at black mark
position
• Autcutting is performed at the black mark position that is below the end-of-printing
position. If the autocutting position is close to the black mark, the black mark may be
skipped and autocutting may be performed at the next black mark position due to paper
slack or variations in the paper, or differences in an individual printer.
• When autocutting is executed by an autocutting command along with paper feeding,
autocutting is performed at the black mark position that is below the position where
autocutting is set.
• For information on continuous multiple label printing, see
Back (non-printing side)
Enabled
-
-
4 mm
{0.16"}
End of printing
Position where autocutting is set
(Specified by command)
Actual autocut position
(Black mark position)
Disabled
Arbitrary stop
Specific stop position
position
Disabled
Approx. 14 mm Paper width 40 mm:
{0.55"} approx. 24 mm {0.94"}
Paper width 80 mm:
approx. 26 mm {1.02"}
"Pattern D" on page
Appendix
Disabled
98.
95