Printing And Cutting Positions - Epson TM-T88 Series Technical Reference Manual

Printing and Cutting Positions

Non-68* models/68* models with paper removal standby disabled
Manual cutter position
Autocutter blade position
Center of the print dotline
68* models with paper removal standby enabled
The print start position is adjustable with back feed.
Manual cutter position
Autocutter blade position
Print start position
Center of the print dotline
90
• The values above may vary slightly as a result of paper slack or variations in the paper.
Take this into account when setting the cutting position of the autocutter.
• To prevent paper jams and for the best print quality, it is recommended to feed the
paper by 1 mm {0.04"} or more after a paper cut.
The printing and autocutting positions change depending on the paper type or the
software setting. ("Printing and Cutting Positions With Software Setting" on page 94)
Approx. 29 mm {1.14"}
Approx. 14 mm {0.55"}
Paper feed direction
Approx. 4 mm
{0.16"}
Approx. 29 mm
{1.14"}
Approx.
14 mm
{0.55"}
Paper feed direction