KROHNE OPTIMASS Series Handbook page 84

Volume Total Fct. 3.2.5.
Parameters for the volume totalizer are selected in this menu.
Key
From
→
↑
↑
→
When selection complete press ↵.
Temperature Fct. 3.2.6.
Selects the temperature units.
Key
From
→
↑
↵
Density Fct. 3.2.7
Allows the selection of density units and measurement resolution.
Key
From
→
↑
→
→
When selection complete press ↵.
Concentration Flow Fct. 3.2.8.
The concentration option has to be activated to access this menu. When this option has not been ordered
the words "Not Fitted" will appear in the display.
If this option was ordered, please refer to separate manual supplied with this option.
Concentration Total Fct. 3.2.9.
As per Fct. 3.2.8
The concentration total will be indicated by the letter "C" in the left corner of the display.
Concentration by mass Fct. 3.2.10.
As per Fct 3.2.8.
Concentration by Volume Fct. 3.2.11
As per Fct. 3.2.8.
Display
Line 1
Fct. 3.2.5
Selects the totalizer display.
00000.000 (cm³)
Selects the units. Selection of cm³, dm³, litre, m³, in³, ft³, US gal,
Impgal, off.
Allows the position of the decimal place to be changed.
Display
Line 1
Fct. 3.2.6
Selects units. Choose from ºC, ºF.
After selection
Display
Line 1
Fct. 3.2.7
00000.000
Allows the selection of the units. Choose from kg, t, oz, Ib, SG, g.
Selects the volume units to be changed. Choose from m³, in³,
ft³,US gal, Impgal, cm³, dm³, litre.
The decimal position can now be selected using the ↑ key.
Installation and Operating Instructions OPTIMASS
Line 2
Volume Tot.
(off) – default is off.
Line 2
Temperature.
ºC.
Line 2
Density.
(kg)/m³.
83