KROHNE OPTIMASS Series Handbook page 57

Examples
The cursor (flashing part of display) has a grey background in the following examples:
To start programming
Measurement mode
1 3. 5 7 1
m 3 /
Note:
When "yes" is set under Fct. 3.5.1 SUPERVISOR, the following will appear in the display after pressing the
→ key:
CodE 1 - - - - - - - - -.
The 9-stroke entry code must now be entered.
Factory setting: → → → ↵ ↵ ↵ ↑ ↑ ↑.
Each keystroke is acknowledged by an " * " in the display.
To terminate programming
Press ↵ key repeatedly until one of the following menus are displayed:
Fct. 1.0 OPERATION, Fct. 2.0 TEST or Fct. 3.0 CONFIG
F c t.
I N S T A L L.
→
h r
Press ↵ key
↵
3. 0
To accept the new parameters
Press ↵ to confirm.
"WAIT" will appear in the display.
The measuring mode will continue after a few seconds
with the new parameters, when no errors are detected.
New parameters not to be accepted
When the new parameters are not to be accepted, the
following keystrokes should be executed:
• Press ↑ key.
•
The display will show "ACCEPT NO".
When the ↵ key is then pressed, the instrument will
return to the measurement mode using the old
parameters.
To review or change parameters further
• Press ↑ key twice
•
The display will show "GO BACK".
When the ↵ key is then pressed, the instrument will
Installation and Operating Instructions OPTIMASS
Programming mode
F c t.
O P E R A T I
A C C E P T.
return to the programming mode
1. 0
O N
Y E S
56