KROHNE OPTIMASS Series Handbook page 64

Fct. Text Description and settings
No
4.5 PULSE OUT. Submenu 4.5 Pulse/frequency output
4.5.1 FUNCTION
Function pulse/frequency output P
* OFF (Output = 0V DC)
* MASS FLOW (Frequency output 0 to MAX Freq. Hz = Mass Flow in range:
* DENSITY (Frequency output 0 to MAX Freq. Hz = Density in range:
* MASS TOTAL(1 pulse = fixed mass as set in Fct 4.5.2)
* VOLUME.FLOW(Frequency output 0 to MAX Freq. Hz = Volume flow in range:
* VOL.TOTAL(1 pulse = fixed volume as set in Fct 4.5.2)
* TEMPERAT. (Frequency output 0 to MAX Freq. Hz = Temperature in range:
CONC. FLOW
CONC. TOTAL
CONC.BY.MASS
CON:BY:VOL.
* DIRECTION (Negative flow gives output of 0 volts DC, Positive flow gives output
* ADDITIONAL(1 pulse = fixed mass as set in Fct 4.5.2)
4.5.2 LOW LIMIT
Value of measured quantity that corresponds to 0 Hz output or
Minimum Width in mS of Pulse for functions MASS TOTAL, VOL. TOTAL or CONC.
or PULSE.WIDTH TOTAL
4.5.3 HIGH LIMIT
Value of measured quantity that corresponds to Max. Frequency or
Mass or volume per pulse value for functions MASS TOTAL, VOL. TOTAL or CONC.
or PULSE VAL. TOTAL
4.5.4 MAX FREQ
Value of max. frequency quantity that corresponds to the max. measured value
Not accessible for functions OFF, MASS TOTAL, VOL. TOTAL or CONC. TOTAL
MIN. FLOW to MAX FLOW as set in Fct. 4.5.2 and 4.5.3)
MIN.DENSITY to MAX.DENSITY as set in Fct. 4.5.2 and 4.5.3)
MIN. V.FLOW to MAX. V.FLOW as set in Fct. 4.5.2 and Fct. 4.5.3)
MIN. TEMP to MAX. TEMP as set in Fct. 4.5.2 and 4.5.3)
of +V volts DC)
Installation and Operating Instructions OPTIMASS
Concentration parameters if option installed.
See separate instruction manual.
63