Table of Contents
Advertisement
General Information
This section provides general information that will help you to use this guide to assemble and install
the PF175 2D Wall Solution storage unit including the required tools, specifications, parts iden-
tification, unit orientation, cleaning, etc.
Tools
The following tools are required to assemble Queenax products:
Note: One set of power tools per installer is recommended.
The following tools are required to assemble Queenax products:
½" Drive hammer drill or Concrete drill
l
masonry bits appropriately sized for anchor types (refer to mfg's guidelines for select-
o
ing anchor bolt bit sizes.)
3 mm, 6 mm, 10.5 mm, and 12.5 mm metal cutting bits
o
½" Drive Battery Impact Driver
l
Battery Angle Grinder
l
Cutting disc and abrasive disc (grit #40)
o
Oscillating Tool (for cutting flooring)
l
Wood and scraper blades
o
Metric tape measure
l
Laser measure
l
Utility Knife
l
Tap driver (10 mm & 12 mm cutting threads
l
Rubber mallet
l
Hammer
l
Ladders
l
Metric combination wrenches (13 mm, 17 mm, comm, and 22 mm)
l
½" and 3/8" drive ratchets
l
1
Torque
wrench 100 ft-lbs (136 N•m
l
Metric hex key set
l
½" metric hex key sockets from (6 mm – 10 mm, 13 mm, 17 mm, comm, and 22 mm)
l
1
Torque is a measure of the force that can cause an object to rotate about an axis. Bolt/nut
example: 5 nM torque is equivalent to 5 newtons of force applied one meter from the center of the
bolt, 6 ft-lb is equivalent to 6 lb of force applied 1 foot away from the center of the bolt.
2 General Information
Tools
3
Advertisement
Table of Contents
