Password Setting; Inverter System Parameter Settings - Eaton Matrix Telecom Inverter System Installation And Operation Manual

Matrix Telecom Inverter System

Password Setting

A new password can be set in SYSTEM option under SETTING.
Press
1
Use
2
desired number is selected.
After a new 4-digit password is input, re-enter the new password as confirmation. Repeat
3
Step 2 to key in the new password again.
The screen will display DONE, when the password is successfully changed.

Inverter System Parameter Settings

Parameter
BaudRate: Baud rate of COM port Selectable at 1) 2400bps, 2) 4800bps and 3) 9600bps
RS422 Addr: RS422 address
Keypad tones: activation or de-
activation of audio alarm
Time&Date: Time and Date
displayed on LCD
Language
Password
Brightness: LCD brightness
Default: Reset Default value
Dryconnet: Dry contact setting
Bat Calib: battery voltage
calibration
36
to enter SETTING PASSWORD menu to change the password.
and to select new password. Press
Copyright © 2008-2010 Eaton Corporation. All Rights Reserved.
IPN 997-00012-68D
to validate each digit of password once the
Specification
RS422 communication protocol
Selectable at 1) Enable or 2) Disable
Time: hh:mm:ss
Date: yyyy-mm-dd
English/ Simplified Chinese/ Traditional Chinese
Setting system password
From 00~63 for adjusting LCD display contrast
Select system type (230V-50Hz or 120V-60Hz).
Press to reset the default value or
Please refer to Default Values on page 71.
Refer to Alarm Settings on page 38.
xx.xxV For regulating the battery voltage value of LCD
display of controller after operating for long period of
time.
The adjustable range is from 20.01V to 69.99V
February 2010
to cancel.