Checking Power Steering Line; Adjusting Toe-In - Kioti DK Series Owner's Manual

CHECKING POWER STEERING LINE

(1) Power Steering
1. Check to see that all hydraulic lines
and hose clamps are tight and
undamaged.
2. If damage is found you should replace
the hose or clamp at once.

ADJUSTING TOE-IN

C86O628A
(A) Wheel - to - wheel distance at rear
(B) Wheel - to - wheel distance at front
1. Park tractor on a flat surface.
2. Turn the steering wheel so front
wheels are in the straight ahead
position.
3. Lower the implement, lock the park
brake and stop the engine.
4. Measure the distance between tire
beads at front of tire, hub height.
5. Measure the distance between tire
beads at rear of tire, hub height.
6. The front distance should be 2 to 8
mm less than rear distance. If not, ad-
just the tie rod length.
C86O629A
(1) Tie-Rod
ADJUSTING PROCEDURE
1. Loosen the lock nut and turn the turn-
buckle to adjust the rod length until the
proper toe-in measurement is obtained.
2. Retighten the lock nut.
MAINTENANCE 6-21
C86O630A
(2) Lock Nut