GENERAL SAFETY RULES WARNING! Read and understand all instructions. Failure to follow al instructions listed below, may result in electric shock, fire and I or serious personal injury. WORK AREA - keep your work area clean and well it. Cluttered benches and dark areas invite accidents.
pull the plug from an outlet. Keep cord away from heat, oil, sharp edges or moving parts. Replace damaged cords immediately. Damaged cord increase the risk of electric shock. - When operating a power tool outside, use an outdoor extension cord marked “W-A”...
Page 6
TOOL USE AND CARE - Use clamps or other practical way to secure and support the workpiece to a stable platform. Holding the work by hand or against your body is unstable and may lead to loss of control. - Do not force tool. Use the correct tool for your application. The correct tool will do the job better and safer at the rate for which it is designed.
Page 7
SERVICE - Tool service must be performed only by qualified repair personnel. Service or maintenance performed by unqualified personnel could result in a risk of injury. - When servicing a tool, use only Identical replacement parts. Follow instructions in the Maintenance section of the manual. Use of unauthorized parts or failure to follow Maintenance instructions may create a risk of electric shock or injury.
Page 8
- Wear a hard hat (safety helmet), safety glasses and/or face shield. Ordinary eye or sun glasses arc NOT safety glasses. It is also highly recommended that you wear a dust mask and thickly padded gloves. - Be sure the bit is secured in place before operation. - Under normal operation, the tool is designed to produce vibration.
Page 9
USING INSTRUCTIONS INSTALL OR REMOVE DRILL BIT CAUTION: please unplug the machine before installing or removing drill bit. Coat a little grease at the connecting end of the drill bit, press down the chuck then insert the connecting end into the chuck hole and release hand from the chuck.
ADJUST DEPTH RULER In the grip base, there is a hole for the depth ruler. Press down the button, insert the depth ruler and move it to desired depth, then release the button to secure it. FORWARD/REVERSE SWITCH When on/off switch trigger released, then the machine is off. Shift the Forward/Reverse switch to forward or reverse drilling.
“ “ and release the small knob, then it “ ” is “ “ for drilling / hammering function. Press down the small knob and turn the big knob till the “ ” to “ “ and release the small knob, then it is for hammering function only.
Page 12
MAINTENANCE & DAILY CARE CAUTION: Always be sure that the tool is switch off and unplugging before attempting to perform inspection and maintenance. 1) The tool and its air vents have to be keep clean, regularly clean the tool’s air vents or whenever the vents start to become obstructed.