Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Ronix 2700
Summary of Contents for Ronix 2700
- Page 1 ROTARY HAMMER 28MM 2700...
-
Page 2: Product Specifications
PRODUCT SPECIFICATIONS Model 2700 Power 850W Voltage 220-240V Frequency 50-60Hz No Load Speed 0-1200RPM Chuck Type SDS Plu Chuck Size 28mm Impact Rate 0-5500BPM Impact Energy 3.5J Steel: 13mm Max Drilling Capacity Concrete: 28mm Wood: 40 mm Weight Scale bar, Extra carbon brush,1 SDS plus drill bit 7×150,1 SDS plus drill bit... -
Page 3: General Safety Rules
GENERAL SAFETY RULES WARNING! Read and understand all instructions. Failure to follow al instructions listed below, may result in electric shock, fire and I or serious personal injury. WORK AREA I) keep your work area clean and well it. Cluttered benches and dark areas invite accidents. -
Page 4: Personal Safety
marked “W-A” or “W”. These cords are rated for outdoor use and reduce the risk of electric shock. PERSONAL SAFETY 9) Stay alert, watch what you are doing and use common sense when operating a power tool. Do not use tool while tired or under the influence of drugs, alcohol, or medication. - Page 5 18) Disconnect the plug from the power source before making any adjustments, changing accessories, or storing the tool. Such preventive safety measures reduce the risk of starting the tool accidentally. 19) Store idle tools out of reach of children and other untrained persons. Tools are dangerous in the hands of untrained users.
- Page 6 shock the operator. 2) Always be sure you have a firm footing. Be sure no one is below when using the tool in high locations. 3) Hold the tool firmly. 4) Keep hands away from rotating parts. 5) Do not leave the tool running. Operate the tool only when hand-held. 6) Do not touch the drill bit or the workpiece immediately after operation;...
- Page 7 USING INSTRUCTIONS INSTALL OR REMOVE DRILL BIT CAUTION: Please unplug the machine before installing or removing drill bit. Coat a little grease at the connecting end of the drill bit, press down the chuck then insert the connecting end into the chuck hole and release hand from the chuck.
-
Page 8: On/Off Switch
Depth ruler Button 4) FORWAED / REVERSE SWITCH When on/off switch trigger released, then the machine is off. Shift the Forward/Reverse switch to forward or reverse drilling. 5) HAMMERING AND DRILLING FUNCION Press down the small knob and turn the big knob till the “ ” to “ ” and release the small knob, then it is for drilling function only. - Page 9 After replacing brushes, plug in the tool break in brushes by running tool with no load for about ten minutes. Then check the tool while running, when releasing the switch trigger. If the tool is not working well, ask your local Ronix service center for repair.
Need help?
Do you have a question about the 2700 and is the answer not in the manual?
Questions and answers