Cisco Catalyst WS-X3001 Installation And Configuration Manual page 31

Connectors, LEDs, and Switches
The following tables describe the connector, LEDs, and switches on the Dual Port Fast Ethernet
module.
Table 10
Name
Network Ports (2) RJ-45; UTP Category 5 Ethernet cable
Table 11
Name
XMIT (Transmit) Green
RCV (Receive)
LINK
DIAG
Table 12
Name
Duplex
Inserting the Dual Port Fast Ethernet With ISL Module
Expansion modules are installed in the expansion slots on the front of the Catalyst switch. All front
expansion modules are installed in a similar way. Use the previous section "Installing The
WS-X3001 (100Base TX) Expansion Module" as an example for detailed installation instructions
and precautions for the Dual Port Fast Ethernet module.
Cabling Dual Port Fast Ethernet With ISL Modules
The Dual Port Fast Ethernet module's network port is either a RJ-45 or SC style connector,
depending upon the model type. The RJ-45 connector uses UTP Ethernet Category 5 cable. The SC
connector uses 1300 nm multimode fiber optic cable. (See the Catalyst Stack Installation and
Configuration Guide for details on cables, connectors, and connections.)
Connector
Description
SC type; multimode fiber optic cable
LEDs
Color Description
Transmitting data
Green Receiving data
Off Link not detected
Green Half-duplex link detected
Amber Full-duplex link detected
Amber Running self-diagnostic
Switches
Position Description
Up Full
Down Half
Catalyst Matrix and Expansion Module Installation and Configuration Guide
ISL Functional Overview and Specifications
31