Cisco Catalyst WS-X3001 Installation And Configuration Manual page 26

Accessing the 100VG Console Screens
Table 7
Port
Type
Link
VG Mode
26 Catalyst Matrix and Expansion Module Installation and Configuration Guide
100VG Port Configuration
Menu Item
The port on the 100VG Module or modules. Possible values:
(17, 19, 21, or 23)
The type of transceiver installed in the 100VG Module:
UTP is the abbreviation for unshielded twisted-pair.
STP is the abbreviation for shielded twisted-pair.
F27 is the abbreviation for the Recessed 100VG Fiber-Optic
Multimode ST Transceiver.
VG-Empty indicates no transceiver is installed.
VG-New indicates a new transceiver was released after the
software was created.
Specifies whether this port has trained or not.
Either:
EndNode. Select EndNode if you will connect this port to a hub
downlink port.
Master. Select Master if you are connecting this port to an end
node PC or another Catalyst switch.
For a Catalyst switch to a Catalyst switch connection, one
module should be set to Master mode and the other should be set
to EndNode.
Auto. Auto tests the cable to see if the port should be a Master
or EndNode mode and automatically selects the correct mode.
After the software selects Master or End Node, either A-Master
or A-EndNode appears in this column. Always connect the cable
from the module to a downlink port on a hub. Do not connect the
cable to an uplink port on the hub.
Description