Cisco Catalyst WS-X3001 Installation And Configuration Manual page 25

Accessing the 100VG Console Screens
By default, the 100VG ports are enabled and do not need configuring. The default Mode setting for
the 100VG ports is Auto Detect (Auto). If a 100VG port needs a specific configuration other than
the default, use the following information to configure that port.
Note
Configuration and Statistic Console Screens
The following sections describe the Catalyst switch console menus that are used to configure ports
and to show the statistics for the 100VG Module.
100VG Port Configuration
The 100VG Port Configuration screen and a 100 VG Port Configuration table are shown below. The
100VG Port Configuration screen is accessed from the Configuration screen.
Figure 17
Use the following list in Table 7 for configuration information for a 100VG port.
A 100VG port cannot be connected to any 100VG port labeled "Uplink."
100VG Port Configuration Screen
100VG Port Configuration
Port Type
17 UTP
Return Change
Return to Previous Menu
Use cursor keys to select action. Press <RETURN> to confirm choice.
Press <CTRL><P> to return to Main Menu.
Catalyst Matrix and Expansion Module Installation and Configuration Guide
Accessing the 100VG Console Screens
Link VG Mode
EndNode
Up
25