Cisco Catalyst WS-X3001 Installation And Configuration Manual page 2

Catalyst Matrix Module Installation
Use the following steps for installing or replacing a Catalyst Matrix module. If you are installing a
module into an open slot, proceed to Step 5.
Step 1
Step 2
Step 3
Step 4
Note
to disengage the module.
Step 5
Step 6
Step 7
Step 8
Figure 1
RD Y
PW R
AC TV
2 Catalyst Matrix and Expansion Module Installation and Configuration Guide
If there is a blank cover over the expansion module slot, remove it by unscrewing the two
attachment screws.
Disconnect power from the module. (See previous note pertaining to power to the module.)
Remove the screw located at the top center of the front of the module.
Use the handle on the front of the module to pull the module straight out from the chassis.
The module may be firmly seated in the chassis; if so, you may need to exert reasonable force
Insert the module into the open slot. In Figure 1, the secondary module is being inserted
into the unit. Place the bottom of the module against the bottom of the slot and slide the
module into the slot. You should feel some resistance as the module connector mates with
the Matrix connector. If you feel solid resistance, pull the module back a little and try again
while moving the module slightly to the left or right until you feel the two connectors
engage. After the connectors start to engage, you should be able to insert the module
approximately one-half inch further or until you feel hard resistance. The connectors
should be seated at that point. If the module fails to work properly, remove it and try this
step again.
Install the screw at the top center of the module's front plate.
Connect the power cord to the module.
Bring the module on line by pressing the ACTIVATE push-button.
Inserting a Secondary Module into a Catalyst Matrix
SW ITC H
ID
AC TIV AT
E
~L IN E 50
/60 Hz
10 0-1 20
VA C, 1.5
20 0-2 40
A
VA C, .75
A
RD Y
PW R
AC TV
SW ITC H
ID
AC TIV AT
E
~L IN E 50
/60 Hz
10 0-1 20
VA C, 1.5
20 0-2 40
A
VA C, .75
A