Table Of Contents - Cisco Catalyst WS-X3001 Installation And Configuration Manual

Matrix and expansion module
Table of Contents

Advertisement

Installing Catalyst Switch Front Expansion Modules
Installing The WS-X3001 (100Base TX) Expansion Module
The modules can be inserted in either of the two expansion slots, as shown in Figure 4.
Use the following steps when installing a module into an expansion slot of the Catalyst chassis.
Caution
from the Catalyst chassis before an expansion module is inserted or removed.
Caution
connector pins when the other end is plugged in. Damage may result from static discharge.
Caution
connector inside the expansion slot. Misalignment may cause the connector pins to bend. When
inserting the module into the expansion slot, be sure that the board is level and that the left and right
sides slide evenly into the slot.
Step 2
Step 3
Step 4
PWR
DIAG
FAUL T
Step 6
Step 7
6 Catalyst Matrix and Expansion Module Installation and Configuration Guide
The Catalyst expansion modules are not hot-swappable. Power must be disconnected
Do not touch the components or connectors on the expansion module. Do not touch cable
During installation, the connector on the expansion module must line up evenly with the
Disconnect the power to the Catalyst switch.
If there is a blank cover over the expansion module slot, or if the slot has an installed
module, remove it by unscrewing the two attachment screws.
Hold the module by the edges to prevent static damage. Be careful not to touch the top or
bottom.
Slide the module into the slot evenly, taking care to line up the edges with the guides.
Inserting a 100BaseTX Expansion Module
XMT
DIA G
1
AUI
1
XMIT
RCV
LNK/ FDX
1
2
3
4
5
6
7
8
9 10 11 12
13 14 15 16
Seat the module by pressing the front of the module with your thumbs.
Secure the module to the chassis by tightening the thumb (panel) screws at the left and right
edges of the expansion modules front panel. Do not overtighten the screws.
Return power to the switch.
FUL L
HAL F
1
2
3
4
5
MDI X
6
7
8
9
XMT
DUP LEX
DIA G
FUL L
1
HAL F
10
11
12
13
14
MDI
15
16
WS -X3 00 1

Advertisement

Table of Contents
loading

Table of Contents