Cisco Catalyst WS-X3001 Installation And Configuration Manual page 18

The WS-X3007 and WS-X3008 100VG Expansion Module
Electromagnetic
Emissions
FCC part 15 Class A
EN55022 / CISPR-22 Class A
VCCI Level 1
Immunity
Complies with Canadian EMC Class A requirements.
Declaration of Conformity for the 100VG Module complies with ISO/IEC Guide 22 and EN 45014.
The declaration identifies the product, the manufacturer's name and address, and the applicable
specifications that are recognized in the European community.
Inserting the 100VG Module
Expansion modules are installed in the expansion slots on the front of the Catalyst switch. All front
expansion modules are installed in a similar way. Use the previous section "Installing The
WS-X3001 (100Base TX) Expansion Module" as an example for detailed installation instructions
and precautions for the 100VG module.
Verifying the Installation
Connect the Catalyst switch to a power source and it will begin its power-on self-test diagnostics.
The following lists the LED pattern that occurs during the diagnostics.
•
•
•
When the self-tests of the Catalyst switch and the 100VG Module complete successfully, the
Catalyst switch and its module(s) are now operational. Connect the appropriate cable to your
transceiver.
See the transceiver section for the cable specifications and instructions.
If the diagnostics fail or if the FAULT LED is on or blinking, refer to the Troubleshooting section at
the end of this document.
18 Catalyst Matrix and Expansion Module Installation and Configuration Guide
At Power On, all LEDs turn on.
The self-test diagnostics for the Catalyst switch and 100VG Module requires approximately 5
minutes. The Catalyst switch DIAG LED and all 100VG Module LEDs are on during this test.
After diagnostics, All LEDs on the module are off.