Cisco Catalyst WS-X3001 Installation And Configuration Manual page 21

Installation Steps
Caution
Use the following steps to install a 100VG Recessed Transceivers. Reverse the installation
procedure to remove a transceiver.
Step 1
Step 2
Step 3
The following illustration shows two twisted-pair transceivers sliding into a 100VG Module.
Figure 14
Step 4
Step 5
Step 6
Disconnect the power to the device in which the transceiver is to be removed or installed.
Disconnect AC power from the networking device or device module; then, using a
flat-bladed or Torx T-10 screwdriver, unscrew the two retaining screws on the 100VG Xcvr
cover plate, or existing transceiver, and remove it from the networking device or device
module.
Touch a grounded, metal object (such as a powered-on hub) to discharge any static
electricity on your body, then carefully remove the transceiver from its protective
anti-static packaging. Hold the transceiver by its edges, taking care not touch any of its
metal connectors.
Slide the transceiver firmly into the 100VG Xcvr slot as far as it will go. The transceiver's
faceplate should touch the face of the device.
100VG Expansion Module Transceiver Insertion
Using the flat-bladed or Torx T-10 screwdriver, tighten the spring-loaded retaining screws
on the transceiver until they are snug. Be careful that you do not overtighten the screws.
Connect network cables to the transceiver or port.
Return power to the unit.
Catalyst Matrix and Expansion Module Installation and Configuration Guide
100VG Recessed Transceivers
21