Resetting The Registration Memory Buttons (Power On Reset) - Yamaha Electone EL-37 Owner's Manual

Registration numbers cannot be entered beyond the Registration Shift
function's capacity of 18. The following message momentarily appears when
the 18 spaces have been filled:
<REGIST SHIFT> ¡EDIT
Data Full...!!
First delete unnecessary registrations, then perform the operation again.

Resetting the Registration Memory Buttons (Power On Reset)

All current settings including Registration Memories and User rhythms can be deleted at once by using the
Power On Reset function. To do this:
1.
Turn oft the power.
2.
While holding down the top left Data Control
button, turn the power back on.
Turning the Electone off erases all panel settings you have made. When the Electone is turned on, Basic
Registration 1 is automatically selected. If you have made panel settings you wish to keep, save them to
Registration Memory before turning the Electone off. You can, however, restore the panel settings that were
made before the Electone was last turned off. In doing this, first be careful NOT to press any panel buttons
(excepting those in Basic Registration) after you turn the Electone back on. Then, to restore the previous
settings, hold down the M (Memory) button and press the D (Disable) button.
Be careful when using this
operation, since it erases all
your existing data. Always save
your important data to a floppy disk
using M.D.R. (See page 56) in advance.
POWER
47