Voice Condition; Feet; Effect - Yamaha Electone EL-37 Owner's Manual

Voice Condition Page 2
<LEAD>
FEET=PRE.EFFECT=PRE.
<UPPER>
FEET=PRE.EFFECT=PRE.

3 Feet

Determines the octave setting of the voice. PRE. (Preset) is the original
(factory) setting; 4' is the highest and 16' is the lowest. Settings: PRE., 4',
8', 16'
By using different Feet settings in the Lower and Upper keyboards and
Pedalboard, you can duplicate the wide octave range of many
instruments. For example, with both the Lower and Upper keyboards set
to the Piano voice and Feet set to appropriate values, you can play the
voice nearly over the full range of a grand piano.
<LEAD>
FEET=PRE.EFFECT=PRE.
Selects next setting.
Selects previous setting.

4 Effect

Determines the effect type applied to the voice. PRE. (Preset) selects the
original (factory) effect, while OFF cancels the effect. This is essentially
an on/off switch for the effects. Settings: PRE., OFF, TRM. (Tremolo),
SYM. (Symphonic), DLY. (Delay), FLG. (Flanger).
<LEAD>
FEET=PRE.EFFECT=PRE.
Though different effects can be applied to different voice sections, only one
effect can be selected at a time for each voice section. (In order to actually
apply the Tremolo, Symphonic/Celeste, Delay and Flanger effects, one more
step is necessary. Refer to the sections on those individual effects below.)
24
3 4
3 4
PRE.
4'
8'
16'
¡2
¡2
¡2
¡2
PRE.
OFF.
Selects next setting.
TRM.
Selects previous setting.
SYM.
DLY.
FLG.
PAGE
These effects are applied in
different degrees depending on
NOTE
the voice selected.