Messages On The M.d.r. Led Display - Yamaha Electone EL-37 Owner's Manual

Messages on the M.D.R. LED Display

Display
No disk is installed. Install a disk.
1)The installed disk is write-protected, so the Record, Song Copy, and
Song Delete jobs cannot be performed. Set the disk's Write-protect tab to
OFF. (See page 49.)
2)If you are using a copy-protected playback-only disk, this message may
appear when you attempt the Record, Song Copy, or Song Delete
operations.
The installed disk is not formatted. Format the disk. (See page 50.)
1)The disk's memory capacity is full, so the Record or Song Copy
operation cannot be performed. Use another formatted disk.
2)Data is already recorded at all song numbers, so the Song Copy
operation cannot be performed. Press the STOP button, then delete any
unnecessary songs.
None of the song numbers contain recorded data, so the Song Copy
operation cannot be performed. Press the STOP button.
An error occurred because the disk was removed during recording or
playback. Press the STOP button, and replace the disk, then start the
operation over again.
The installed disk cannot be played back on the M.D.R. Press the STOP
button, then insert a compatible disk.
Recording cannot be performed because too much data was received at
once. Press the STOP button.
The disk is defective and cannot be formatted. Press the STOP button,
then insert another disk.
An error occurred during the transmission or reception of data. Press the
STOP button.
You are trying to record to the song number which already contains
XX *
recorded data. Select the other blank song number by pressing the
SONG SELECT buttons. * "XX" indicates a song number (01 through 40).
When you insert the "copy-protected" disk to the Electone, this message
XX *
will appear on the LED display. You cannot overwrite or save the
changes. * "XX" indicates a song number (01 through 40).
In the case of Voice Disk operation, an incompatible Voice Disk has been
inserted.
Description of the Messages
67