Table 1-2. Direct-Mount Terminal Blocks - National Instruments SCXI-1000 Getting Started

Module
SCXI-1100, SCXI-1300
SCXI-1102/B/C
SCXI-1303
SCXI-1308
SCXI-1310
SCXI-1104/C SCXI-1300
SCXI-1112 N/A
SCXI-1120/D, SCXI-1320
SCXI-1121,
SCXI-1321
SCXI-1125
(for
SCXI-1121)
SCXI-1327
SCXI-1328
SCXI-1330
SCXI-1338
SCXI-1122 SCXI-1322
SCXI-1124 SCXI-1325
SCXI-1126 SCXI-1305
SCXI-1320
SCXI-1327
© National Instruments Corporation

Table 1-2. Direct-Mount Terminal Blocks

Terminal/
Connector Terminal Block or
Block Connector and Shell
Terminal block
Terminal block
Terminal block
Connector and shell
Terminal block
No terminal block
required
Terminal block
Terminal block
Terminal block
Terminal block
Connector and shell
Terminal block
Terminal block
Terminal block
Terminal block
Terminal block
Terminal block
CJC
Sensor
Yes
Yes 1 Isothermal, signal referencing, and open
thermocouple detection
No 0–20 mA and 4–20 mA current input
No Low-cost connector-and-shell assembly
Yes
N/A Connect thermocouples directly using
mini-thermocoupleconnectors,built-inCJC
sensor per channel
Yes
Yes Offset-nulling and shunt calibration for
strain gauges
Yes 1 100:1 attenuation of voltages to 250 V
switch configurable per channel
Yes 1 Isothermal design for thermocouples
No Low-cost connector-and-shell assembly
No 0–20 mA and 4–20 mA current input
Yes
1
No
No AC/DC coupling, signal referencing,
switch-configurable per channel, BNC
connectors
Yes
Yes 100:1 attenuation of voltages to 250 V
1
switch configurable per channel
1-9
Chapter 1 Introduction to SCXI
Other Features
—
—
—
—
—
—
Getting Started with SCXI
2
,
rms
2
,
rms