You must use 2-wire ferrules to create a secure connection when connecting
■
more than one wire to a single terminal on the NI 9206.
Push the wire into the terminal when using a solid wire or a stranded wire
■
with a ferrule.
Open the terminal by pressing the push button when using stranded wire
■
without a ferrule.
Connecting to a Spring-Terminal Connector
What to Use
NI 9206 spring-terminal connector
■
2
0.08 mm
to 1.0 mm
■
(0.28 in.) of insulation stripped from the end
Flathead screwdriver with a 2.3 mm x 1.0 mm (0.09 in. x 0.04 in.) blade,
■
included with the NI 9206
What to Do
Complete the following steps to connect wires to the spring-terminal connector.
1. Insert the screwdriver into a spring clamp activation slot to open the
corresponding connector terminal.
2. Press a wire into the open connector terminal.
2
(28 AWG to 18 AWG) copper conductor wire with 7 mm
1
2
NI-9206 Getting Started
3
© National Instruments
13