National Instruments SCXI-1000 Getting Started page 99

Table 4-1. SCXI Module and Connector Compatibility (Continued)
Module
SCXI-1140 SCXI-1301
SCXI-1141 SCXI-1304
SCXI-1142 SCXI-1305
SCXI-1143 SCXI-1310
SCXI-1160 SCXI-1324
SCXI-1161 —
SCXI-1162 SCXI-1326
SCXI-1162HV TBX-1326
SCXI-1163
SCXI-1163R
SCXI-1180 SCXI-1302
SCXI-1181 SCXI-1301
SCXI-1310
SCXI-1330
2
SCXI-1200 SCXI-1302
SCXI-1520 SCXI-1314
SCXI-1530 —
SCXI-1531
SCXI-1540 SCXI-1315
All modules TBX-24F
1
The SCXI-1330 connector is keyed for use with high-voltage modules. To use the SCXI-1330 with the
SCXI-1181, you must remove the keys by sliding the two coding wedges from their dovetail grooves. The
SCXI-1181 is not intended for use with hazardous voltages (exceeding 42 V
liable for damages or injuries resulting from improper installation.
2
To connect signals to the SCXI-1200, you can also use a CB-50, a CB-50LP, a BNC-2081, or an SC-2071.
3
The TBX-24F is a general-purpose feedthrough connector that mounts on a DIN rail.
© National Instruments Corporation
Terminal/
Connector Cold-Junction Sensor
1
3
Chapter 4 Connecting and Using Accessories and Transducers
Features
Isothermal
No
No
No
No
No
No
No
No
No
No
No
No
No
Yes
No
No
No
4-3
Others
No Used with
SCXI-1140 only
No AC/DC coupling
No AC/DC coupling
No Low-cost
connector and shell
No —
No —
No —
No —
—
—
No —
No —
No —
No —
No —
No Quarter-bridge
completion, shunt
calibration
resistors
No —
No —
No —
). National Instruments is not
rms
Getting Started with SCXI