6.
Touch any metal part of the chassis to discharge static electricity.
7.
Ensure that the ejector handle is in the unlatched (downward) position.
8.
Place the module edges into the module guides at the top and bottom of the chassis. Slide
the device into the slot until it is fully inserted.
1. Chassis
2. Hardware Module
3. Ejector Handle in Down (Unlatched Position)
9.
Latch the module in place by pulling up on the ejector handle.
10. Secure the device front panel to the chassis using the front-panel mounting screws.
Note
stability and also electrically connects the front panel to the chassis, which can
improve the signal quality and electromagnetic performance.
11. Cover all empty slots using filler panels or slot blockers to maximize cooling air flow.
12. Power on the chassis.
Related Information
Installing the Software
Direct Connections to the NI 5693
The NI 5693 is a precision RF instrument that is sensitive to ESD and transients. Ensure you
take the following precautions when making direct connections to the NI 5693 to avoid
damaging the device.
Figure 2. Module Installation
2
3
Tightening the top and bottom mounting screws increases mechanical
on page 4
1
NI PXIe-5693 Getting Started Guide | © National Instruments | 5