Left Handlebar; Clutch Lever Adjustment; Turn Signal Light Switch; Hazard Warning Switch - Suzuki GSF1250 Owner's Manual

CLUTCH LEVER
G)
The clutch lever is used for disengag-
ing the drive to the rear wheel when
starting the engine or shifting trans-
mission gears. Squeezing the lever
disengages the clutch.
Clutch Lever Adjustment
The distance between the grip and
the clutch lever is adjustable to 4 posi-
tions. To change the position, push
the clutch lever forward and turn the
adjuster to the desired position. When
changing the clutch lever position,
always be sure the adjuster stops in
the proper position; a projection of the
clutch lever holder should fit into the
depression of the adjuster. This
motorcycle is delivered from the fac-
tory with its adjuster set on position 2.
A
WARNING
Adjusting the clutch lever position
while riding can be hazardous.
Removing a hand from the handle-
bars can reduce your ability to
control the motorcycle.
Always keep both hands on the
handlebars while riding.
2-14
HEADLIGHT FLASHER SWITCH (2)
Press the switch to flash the head-
light.
DIMMER SWITCH @
"~D" position
The headlight low beam and taillight
turn on.
" D" position
(GSF1250)
The headlight high beam and taillight
turn on. The high beam indicator light
lso turns on.
(GSF1250S)
The headlight high beam, headlight
I w beam and taillight turn on. The
high beam indicator light also turns
n.
F1250)
CAUTION
Holding the dimmer switch
between "~D" and "~D" position
will light both "~D" and "~D"
headlight beam. This operation
can damage the motorcycle.
Use the dimmer switch only at
" D" or "~D" position.
CAUTION
Sticking some tape or placing
objects in front of the headlight
can damage the headlight.
Do not stick any tapes to the head-
light. Do not place objects in front
of the headlight.
TURN SIGNAL LIGHT SWITCH
"<=iq"
@
Moving the switch to the
"="
position
will flash the left turn signals. Moving
the switch to the "=" position will
flash the right turn signals. The indi-
cator light will also flash intermittently.
To cancel turn signal operation, push
the switch on.
A
WARNING
Failure to use the turn signals,
and failure to turn off the turn sig-
nals can be hazardous. Other driv-
ers may misjudge your course and
this may result in an accident.
Always use the turn signals when
you intend to change lanes or
make a turn. Be sure to turn off
the turn signals after completing
the turn or lane change.
HORN SWITCH "~" @
Press the switch to operate the horn.
HAZARD WARNING SWITCH"&,."
@
All tour turn signal lights and indica-
tors will flash simultaneously when
the switch is turned on with the igni-
tion switch in the "ON" or "P" position.
Use the hazard warning lights to warn
other traffic during emergency park-
ing or when your motorcycle could
otherwise become a traffic hazard.
2-15