Engine Idle Speed Inspection - Suzuki GSF1250 Owner's Manual

Mark top dead center
11. Pour 3500 ml (3.7/3.1 US/Imp. qt)
of new oil through the filler hole
and install the filler cap. Be sure to
always use the specified engine
oil described in the FUEL,
ENGINE OIL AND COOLANT
RECOMMENDATIONS section.
NOTE: About 3000 ml (3.2/2.6 US/
Imp. qt) of oil will be required when
changing oil only.
CAUTION
Engine damage may occur if you
use oil that does not meet
Suzuki's specifications.
Use the oil specified in the FUEL,
ENGINE OIL AND COOLANT REC-
OMMENDATIONS section.
12. With the engine running, look
carefully for leaks at the oil filter
and drain plug. Run the engine at
various speeds for 2 to 3 minutes.
13. Stop the engine and wait a few
minutes. Check the oil level again.
Engine oil level can be inspected
through the inspection window
while holding the motorcycle
verti-
cally. If the oil level is lower than
the "I.:' line add new oil until it
reaches the "F" line. Check for
leaks again.
NOTE:
If
you do not have a proper oil
filter wrench, have your Suzuki dealer
perform this service.
Tighten the filter 2 turns or
to specified torque.
1
o.
Mark the top dead center position
on the "cap type" filter wrench or
on the oil filter. Use an oil filter
wrench to tighten the filter 2 turns
or to specified torque.
Oil filter tightening torque:
20 N-m (2.0 kgf-m, 14.5 lbf-ft)
ENGINE IDLE SPEED INSPECTION
Inspect the engine idle speed. The
engine idle speed should be 1100 -
1300 r/min when the engine is warm.
NOTE:
If
the engine idle speed is not
within the specified range, ask your
Suzuki dealer or a qualified mechanic
to inspect and repair the motorcycle.
6-18 6-19