Siemens SIMATIC ET 200MP System Manual page 91

Procedure
1. Orient yourself to the labeling on the power cable connector.
2. Orient yourself to the red marking on the coding element.
3. The coding element has 3 red markings. Turn the coding element in such a way that one
4. Insert the coding element into the back side of the power cable connector, until you hear
ET 200MP Distributed I/O System
System Manual, 01/2013, A5E03723484-01
9.3 Coding element on the power connector of the power supply module
Figure 9-6 Labeling on the power cable connector
of the 3 red markings corresponds to the voltage indicated on the connector.
it click into place. The figure below shows you how to insert a coding element into a
power cable connector for 24 V DC.
Figure 9-7 Inserting a coding element into the power cable connector
Maintenance
91