Siemens SIMATIC ET 200MP System Manual page 6

Table of contents
6.5 Connecting supply voltage to the interface module .................................................................... 58
6.6 Connecting supply voltage to the power supply module............................................................. 59
6.7 Connecting PROFINET IO via the RJ45 bus connector to the interface module ....................... 61
6.8 Front connector for the I/O modules ........................................................................................... 63
6.8.1 Characteristics of the front connector ......................................................................................... 63
6.8.2 Wiring front connectors for I/O modules without shield contact element.................................... 64
6.8.3 Wiring front connectors for I/O modules with shield contact element......................................... 66
6.8.4 Bringing the front connector into final position ............................................................................ 72
6.9 Marking the I/O modules ............................................................................................................. 74
6.9.1 Labeling strips ............................................................................................................................. 74
6.9.2 Optional marking ......................................................................................................................... 75
7 Configuring .............................................................................................................................................. 77
7.1 Selection of the power supply (PS) module ................................................................................ 77
7.2 Selection of the load power supply (PM) .................................................................................... 78
8 Commissioning ........................................................................................................................................ 79
8.1 Commissioning the ET 200 MP .................................................................................................. 79
8.2 Startup of the ET 200MP............................................................................................................. 80
8.3 Identification data ........................................................................................................................ 81
8.3.1 Reading out and entering I&M data ............................................................................................ 81
8.3.2 Record structure for I&M data ..................................................................................................... 82
8.4 Protection by locking the interface module ................................................................................. 84
9 Maintenance ............................................................................................................................................ 85
9.1 Removing and inserting I/O modules.......................................................................................... 85
9.2 Replacement of I/O modules and front connectors .................................................................... 86
9.2.1 Coding element on the I/O module and on the front connector .................................................. 86
9.2.2 Replacing an I/O module............................................................................................................. 88
9.2.3 Replacing a front connector ........................................................................................................ 89
9.3 Coding element on the power connector of the power supply module....................................... 90
9.4 Firmware update ......................................................................................................................... 92
9.5 Resetting interface module to factory settings ............................................................................ 93
10 Technical specifications ........................................................................................................................... 95
10.1 Standards and approvals ............................................................................................................ 95
10.2 Electromagnetic compatibility ................................................................................................... 100
10.3 Shipping and storage conditions............................................................................................... 102
10.4 Mechanical and climatic ambient conditions............................................................................. 103
10.5 Information on insulation, protection class, degree of protection and rated voltage ................ 105
10.6 Use of the ET 200MP in zone 2 potentially explosive atmospheres......................................... 106
6
ET 200MP Distributed I/O System
System Manual, 01/2013, A5E03723484-01