Optional Configurations - Graco Fusion A Series Instructions Manual

Optional Configurations

Change Fluid Manifold Position
The fluid manifold is mounted to bottom of gun, with A
side on left, viewed from operator's position at back of
gun. If desired, manifold may be moved to top of gun.
Doing this will reposition A side parts (fluid inlet swivel,
check valve, side seal cartridge, and mix chamber) to
the right.
To prevent cross-contamination in the gun, do not
interchange A component (isocyanate) and B
component (resin) parts. Cross-contamination can
result in cured material in the gun. Cured material may
damage the sealing surfaces, block fluid passages,
and prevent gun function.
1. Follow the Pressure Relief Procedure, page 19.
2. Disconnect air line quick coupler (D) and remove
fluid manifold (M).
F
M
3. Remove Front End, page 30.
4. Rotate the fluid housing (F) 180 degrees.
5. Attach Front End, page 30.
6. Reattach fluid manifold. Reconnect air line. Return
gun to service.
3A7314B
NOTICE
D
TI2554A
Change Hose Position
The fluid inlet swivels and air quick disconnect fitting
point to the rear of the gun. If desired, these positions
can be changed so hoses travel downward.
To prevent cross-contamination in the gun, do not
interchange A component (isocyanate) and B
component (resin) parts. Cross-contamination can
result in cured material in the gun. Cured material may
damage the sealing surfaces, block fluid passages,
and prevent gun function.
1. Follow the Pressure Relief Procedure, page 19.
2. Relieve the system pressure. Follow the Pressure
Relief Procedure in your proportioner manual.
3. Disconnect air line (D) and remove fluid manifold
(M).
M
4. Disconnect fluid hoses from fluid inlet swivels (S).
Remove swivels. Remove plugs from optional inlets
(P).
S
Installation
NOTICE
D
TI2554A
S
P
TI2417A
17