Setup - Graco Fusion A Series Instructions Manual

Installation
4. Install the front retaining ring (U).
a. Lubricate the front retaining ring (U). See
Lubricant for Gun Rebuild, page 43.
b. Tighten the front retaining ring (U) until the PC
fluid cartridge (Y) is fully engaged and secure in
the fluid housing (F).
U
To prevent damage to the fluid o-ring or injury from
splashing chemical, verify that the fluid cartridge (Y) is
fully engaged into the fluid housing (F), and the front
retaining ring (U) is tight.
5. Install the air cap (C).
C
14
F

Setup

1. Close fluid valves A and B.
2. Connect A (ISO) and B (RESIN) fluid hoses to fluid
manifold (M).
B (RESIN)
M
3. Engage the piston safety lock (L). See Piston
Safety Lock, page 20.
L
4. Connect gun air whip hose (V) and air valve (W) to
main air hose. Attach fluid manifold (M) to gun.
M
ti2411a
A (ISO)
TI2417A
TI2409A
V
W
TI2554A
3A7314B