Security And Installation Guidelines - Kamstrup OMNIPOWER Installation Manual

OMNIPOWER – three-phase
Connect the meter in accordance with the installation diagram on the meter's type label.
Depending on the configuration, a fixed value is displayed, or the display changes between select-
ed indications every 10 seconds.
It is possible to change the display reading manually by activating the push button on the meter.
The available readings depend on the meter's configuration.

Security and installation guidelines

The meter is only to be used for measuring electrical energy and shall operate within the specified
values only.
The meter must be disconnected when working on it. It can be highly dangerous to touch the meter
parts when the meter is switched on.
Therefore, the relevant security fuse must be removed and kept in a place where it cannot be
inserted by unauthorized persons.
Current local standards, guidelines, regulations and instructions must be observed. Only author-
ized personnel is permitted to install electricity meters.
Meters for direct connection must be protected against short circuit by a security fuse in accord-
ance with the maximum current stated on the meter.
Failing to obey the "Guidelines for safety and installation", the guarantee no longer applies.
Secondary module
LCD display
Optical interface
LED (meter constant)
LED breaker status
(only meters with
internal breaker)
Push button
Sealable push button
Type label
Utility seals
The meter constant LED blinks proportionally to the consumed active energy.
Only authorized personnel may break the utility sealing.
2 Kamstrup A/S • 55121316_E1_GB_10.2016