Nice Era Plus H Series Instructions And Warnings For Installation And Use page 7

A
04
B
04
C
04
D
04
5.8 - Memorising a SECOND (third, fourth, etc.) transmitter
Caution! To perform these procedures, you must have another transmitter already memorised.
5.8.1 - Memorising a second transmitter using "Mode I"
Caution! – This procedure memorises the new transmitter in "Mode I", regardless of the Mode in which the old transmitter was memorised.
Before starting the procedure, bring the awning/shutter to a point half-way along its course.
01. (on the new transmitter) Keep the n key pressed for 8 seconds and then release it (in this case the motor does not perform any movement).
02. (on the old transmitter) Give 3 pulses on the key n, provided that it is stored.
03. (on the new transmitter) Press the n key once to complete the procedure. Caution! – If the motor performs 6 movements, it means that its memory is full.
01
New
N.B. – When performing the procedure, you can cancel the memorisation at any time by keeping the n and s keys pressed simultaneously for 4 seconds Alternatively,
do not press any keys and wait 60 seconds for the motor to complete 6 movements.
––– Procedure 5.8.1 ––– executable only with a series transmitter Era P and Era W
01
Old
02
PRG
New
...
...
...
...
02
8
sec.
Old
PRG
6
2
sec.
PRG
6
2
sec.
05
Adjust to the height "1" desired
05
Adjust to the height "1" desired
05
Adjust to the height "1" desired
05
Adjust to the height "1" desired
03
X 3
0,5
sec.
PRG
...
2
03
PRG
1
sec.
Old
0,5
sec.
New
3
...
"1"
...
"1"
...
"1"
...
"1"
Inglese – 6