Nice Era Plus H Series Instructions And Warnings For Installation And Use page 5

5.5 - Memorisation of the FIRST transmitter
Warning – Every time the motor is powered, 2 movements are performed, if there is not at least one transmitter and the limit switch
heights in its memory.
Before starting the procedure, bring the awning/shutter to a point half-way along its course.
01. Disconnect the power supply to the motor; wait two seconds and reconnect the power supply: the motor performs 2 movements.
02. Keep the n key pressed and wait for the motor to perform 3 movements. Upon completion, release the key.
01
OFF
5.6 - Combination of the UP and DOWN directions of the awning/shutter with their
respective keys s and t on the command device
This procedure can only be done with a "Mode I" transmitter.
Before starting the procedure, bring the awning/shutter to a point half-way along its course.
01. Keep the n key pressed and wait for the motor to perform 2 movements. Upon completion, release the key.
02. Keep the s and t keys pressed simultaneously and wait for the motor to perform 3 movements. Upon completion, release the keys.
03. Keep the s key pressed and...
• if the shutter starts to move in the direction UP, keep the s key pressed and wait for the motor to perform 3 movements. Upon completion, release the key.
• if the shutter starts to move in the direction DOWN, release the s key and keep the t key pressed, waiting for the motor to perform 3 movements. Upon
completion, release the key.
01
5
sec.
03
...
sec.
N.B. – When performing the procedure, you can cancel the programming at any time by keeping the n and t keys pressed simultaneously for 4 seconds Alternatively,
do not press any keys and wait 60 seconds for the motor to complete 6 movements.
––– Procedure 5.6 ––– executable only with a series transmitter Era P and Era W
01
PRG
5
sec.
04
PROCEDURES
ON
2
2
sec.
02
2
...
02
PRG PRG
2
...
02
5
sec.
5
3
sec.
3
6
sec.
PRG
5
2
sec.
3
...
3
03
5
2
sec.
Inglese – 4