Nice Era Plus H Series Instructions And Warnings For Installation And Use page 11

5.11 - Memorisation of a climate sensor connected via radio (ref. paragraph 6.2.2)
To perform the procedure you must have a transmitter memorised in "Mode I".
Before starting the procedure, bring the awning/shutter to a point halfway along its course.
01. (on the climate sensor) Keep the yellow key pressed for 10 seconds and then release it (in this case the motor does not perform any movement).
02. (on the old transmitter) Give 3 pulses on the n key, provided that this is memorised.
03. (on the climate sensor) Keep the yellow key pressed for 2 seconds: the motor performs 3 movements to confirm its memorisation. Caution! – If the motor performs
6 movements, it means that its memory is full.
01
N.B. – When performing the procedure, you can cancel the programming at any time by keeping the n and t keys pressed simultaneously for 4 seconds Alternatively,
do not press any keys and wait 60 seconds for the motor to perform 6 movements.
5.12 - Programming the movement (Ascent or Descent) that the motor must perform
automatically when it starts to rain (ref. paragraph 6.2.4)
Before starting the procedure, bring the awning/shutter to a point halfway along its course.
01. Keep the n key pressed and wait for the motor to perform 2 movements. Upon completion, release the key.
02. Keep the t key pressed and wait for the motor to perform 3 movements. Upon completion, release the key.
03. Keep the n key pressed and wait for the motor to perform 2 movements. Upon completion, release the key.
04. Programme the movement that the motor must perform automatically when it starts to rain, by selecting one of the following options:
• to programme the Raising of the awning (or shutter): keep the s key pressed and wait for the motor to perform 3 movements.
Upon completion, release the key.
• to programme the Lowering of the awning (or shutter): keep the t key pressed and wait for the motor to perform 3 movements.
Upon completion, release the key.
01
5
sec.
=
=
N.B. – When performing the procedure, you can cancel the programming at any time by keeping the n and t keys pressed simultaneously for 4 seconds Alternatively,
do not press any keys and wait 60 seconds for the motor to perform 6 movements.
––– Procedure 5.12 ––– executable only with a series transmitter Era P and Era W
01
PRG
1
sec.
04
PROCEDURES FOR OPTIONAL ACCESSORIES (ref. Chapter 6)
02
"P1" "P1"
10
sec.
Old
02
2
04
5
3
sec.
04
5
3
sec.
02
PRG
1
2
sec.
03
X 3
0,5
sec.
5
3
sec.
03
5
2
sec.
05
"P1"
2
sec.
03
5
2
sec.
3
3
Inglese – 10