Nice Era Plus H Series Instructions And Warnings For Installation And Use page 12

sec.
04
5
2
sec.
5.13 - Resistive sensitive edge (can only be connected to the photocell couple) (ref. paragraph 6.4)
Before starting the procedure, bring the awning/shutter to a point half-way along its course.
01. Keep the n key pressed and wait for the motor to perform 2 movements. Now release the button.
02. Keep the n key pressed and wait for the motor to perform 4 movements. Upon completion, release the key.
03. Keep the n and s keys pressed simultaneously and wait for the motor to perform 2 movements. Upon completion, release the key.
04. Then choose the desired function you wish to assign to the motor and keep the key combined with the chosen function pressed; wait for the motor to perform 3
movements and, upon completion, release the key.
• after the intervention of the edge, the motor performs a brief reverse movement and stops (= press the s) key.
• after the intervention of the edge, the motor stops without performing the brief reverse movement (= press the n) key.
• after the intervention of the edge, the motor stops and then starts again in the upward direction (= press the t) key.
01
...
03
4
5
sec.
N.B. – When performing the procedure, you can cancel the programming at any time by keeping the n and t keys pressed simultaneously for 4 seconds Alternatively,
do not press any keys and wait 60 seconds for the motor to complete 6 movements.
To delete the setting you have selected and reconfigure the input for a climate sensor, you must delete the positions of the limit switches "0" and "1" (section 5.9).
11 – Inglese
2
sec.
" 1 "
04
05
=
5
sec.
05
=
5
sec.
05
=
"1"
5
sec.
2
sec.
05
=
5
sec.
05
=
5
sec.
02
2
5
sec.
2
5
sec.
3
3
3
3
3
3