Operating Style Playback - Yamaha CLAVINOVA CVP-501 Owner's Manual

Operating Style Playback

To Start/Stop Playing
• [START/STOP] button
Style starts playing back as soon as the [START/STOP] but-
ton is pressed. To stop playback, press the button again.
• [SYNC START] button
This puts the Style playback in "standby." The Style starts
playing back when you press any note on the keyboard (when
[ACMP ON/OFF] is off) or you play a chord with your left
hand (when [ACMP ON/OFF] is on). During the Style play-
3
back, pressing this button stops playing and puts the playback
in "standby."
• [SYNC STOP] button
You can start and stop the Style anytime you
want by simply playing or releasing the keys
in the chord section of the keyboard. Make
sure that the [ACMP ON/OFF] button is on,
press the [SYNC STOP] button, then play the
keyboard.
• INTRO [I] – [III] buttons
The instrument features three different Intro sections to add an
introduction before starting the Style playback. After pressing
one of the INTRO [I] – [III] buttons, start playback by using the
[START/STOP] button or [SYNC START] button. When the
Intro finishes playing, the Style playback automatically shifts to
the Main section.
• ENDING/rit. [I] – [III] buttons
The instrument features three different Ending sections to add an
ending before stopping Style playback. When you press one of
the ENDING [I] – [III] buttons while Style is playing back, the
Style will automatically stop after the ending is played. You can
have the ending gradually slow down (ritardando) by pressing
the same ENDING button once again, while the ending is
playing.
About the lamp status of the section buttons (INTRO/MAIN VARIA-
TION/BREAK/ENDING)
• Red: The section is currently selected.
• Red (flashing): The section will be played next, following the currently selected
section.
*The Main [A]-[D] buttons also flash red during fill-in playback.
• Green: The section contains data but not currently selected.
• Off: The section contains no data and cannot be played.
52
CVP-509/505/503/501 Owner's Manual
NOTE
When the fingering mode is set to
"Full Keyboard" or "AI Full Key-
board," Synchro Stop cannot be
turned on.
To change the fingering mode:
[FUNCTION] → [C] STYLE SETTING/
SPLIT POINT/CHORD FINGERING →
TAB [E][F] CHORD FINGERING.
NOTE
If you press the ENDING/rit. [I] button
when the Style is playing, a fill-in
automatically plays before the END-
ING/rit [I].