Table of Contents
Advertisement
Figure 29 Example CLI configuration
You can configure the IP71 with CLI using the CLI Quick Setup Wizard.
Configuring the IP71 using CLI involves providing the same information as
when configuring using secure Web-based GUI.
1. Enter the default login username (admin) and password (password). An
Nokia IP71 User Guide
set ipinterface table
This command is used to set the IP Address of the LAN & WAN
port of IP71.
Syntax:
set ipinterface table index=<LAN/WAN> ipaddress=
<ip_address>mask=<ip_address>mtu=<n(0....1500)>status=<up
/down>
Options:
index - LAN / WAN
ipaddress - IP Address of the LAN / WAN port
mask - Netmask of the LAN / WAN port
Status - down / up
mtu - To set the mtu value of the LAN / WAN port and its
value is between 70 to 1500.
Example:
Set ipinterface table index=lan ipaddress=192.168.1.2
mask=255.255.255.0 state=up
IP71 prompt appears and you can begin the system configuration.
Configuring Using the GUI
75
Advertisement
Table of Contents
