Nokia IP71 User Manual page 18

1
Overview
Figure 3 Upgrade using CLI
Note
The SSH host fingerprint must be configured for SCP to work. The set
command is not executed unless you enter the command=start
command.
Configure the parameters for TFTP/SCP and enter set command
to upgrade.
Note
Users with IP71 v1.0 or v1.1, use CLI to upgrade the IP71. Use HTTPS-
based GUI using after you upgrade to v1.6 or later.
18
set upgrade
Use this command to set the upgrade values like file name,
server address etc.
Syntax:set upgrade file= <file (0...250)>ipaddress=
<ip_address> protocol=<SCP/TFTP>user=<user=(0...250)>
password=<password(0...250)>command=start
Options:File=File name of the binary.
IP address=IP address of the TFTP or SCP server.
Protocol=TFTP or SCP
User=Username of SCP server (If you select SCP)
Password=Password of the SCP server for the user.(If you
select SCP)
Command=start (After configuring all above parameters,
start the upgrade)
Example: Set upgrade file=ip71fr0115.bin
ipaddress=192.168.2.10 protocol=scp user=mchris
password=chris command=start
=start
Nokia IP71 User Guide