Removing Cutterbar - MacDon R216 Installation Instructions Manual

3.4 Removing Cutterbar

WARNING
Exercise caution when working around the blades. Blades are sharp and can cause serious injury. Wear gloves when
handling blades.
CAUTION
The cutterbar weighs approximately 560 kg (1300 lb.). Use a suitable lifting device to support and move the cutterbar
into place.
1. Support the header with a forklift underneath the frame
beams. Set cutterbar on stands.
2. With the header supported, remove hardware (H) and (J)
that secure the endplate to the cutterbar.
3. With the cutterbar on a stand, remove bolts (C), (D), (E), (F),
and (G) that secure the cutterbar to the frame at
locations (A) and (B).
4. Repeat Steps 1, page 13
of the cutterbar.
5. Slowly lift the header away from the cutterbar.
215339
INSTALLATION INSTRUCTIONS
to 3, page 13 at the opposite end
H
J
Figure 3.15: Cutterbar Bolts – Bottom View
13
D
B
A
C
E F
Revision A
G