MacDon R216 Installation Instructions Manual page 24

20. Apply high-strength threadlocker (Loctite
equivalent) to two M16 bolts with two washers (A), and
install the hardware into the end of the cutterbar through
the slots on endplate (B). Torque bolts to 249 Nm
(184 lbf·ft). Repeat at the opposite side of the cutterbar.
21. Remove the four M12 bolts securing drive alignment
tool (A) to drive alignment adapter (B).
22. Remove four bolts (A) and drive alignment adapter (B).
23. Remove drive alignment tool (C).
215339
INSTALLATION INSTRUCTIONS
®
262 or
Figure 3.26: Cutterbar Endplate – Bottom View, Left
End Shown, Right End is Opposite
Figure 3.27: Alignment Tool on Right Driven Drum,
Left Driven Drum is Opposite
Figure 3.28: Alignment Tool on Right Driven Drum,
Left Driven Drum is Opposite
18
B
A
B
A
B
A
A
C
Revision A