MacDon R216 Installation Instructions Manual page 4

Summary of Changes
At MacDon, we're continuously making improvements, and occasionally these improvements affect product
documentation. The following list provides an account of major changes from the previous version of this document.
Section
OVERALL
3.1 Opening Cutterbar Curtain,
page 7
3.2 Removing Left Driveline, page
9
3.3 Removing Right Driveline,
page 11
3.6 Installing Cutterbar, page 15
3.7 Installing Left Driveline, page
20
3.8 Installing Right Driveline,
page 22
3.9 Closing Cutterbar Curtain,
page 24
215339
Summary of Change
Cutterbar kit MD #307756 superseded by MD #338109.
Kit instruction MD #214859 replaced by MD #215339.
Changed image to better show engagement of header safety prop
and be consistent with operator's and technical manuals. Updated
illustration from 1030015 to 1029808 to show change.
Updated Step 1 to remove four M10 hex flange head bolts instead
of two. Updated illustration from 1028233 to 1033148 to show
change.
Updated Step 1 to remove four M10 hex flange head bolts instead
of two. Updated illustration from 1028513 to 1033149 to show
change.
Added information with the differences to model year 2019 and
2020. Removed illustration 1031508 and replaced with
illustrations 1032908, 1032904, and 1032905 to clarify.
Updated Step 7 to install four M10 hex flange head bolts instead
of two. Updated illustration from 1028233 to 1033148 to show
change.
Updated Step 7 to install four M10 hex flange head bolts instead
of two. Updated illustration from 1028513 to 1033149 to show
change.
Changed image to better show disengagement of header safety
prop and be consistent with operator's and technical manuals.
Updated illustration from 1030015 to 1029799 to show change.
ii
Internal Use
Only
ECN 60170
Tech Pubs
Engineering
Engineering
Tech Pubs
Engineering
Engineering
Tech Pubs
Revision A