Electronic Gearing - Galil Motion Control DMC-14 5 Series Manual

Example:
Traverse the path shown in Fig. 6.3. Feedrate is 20000 counts/sec. Plane of motion is XY
Instruction
VM XY
VS 20000
VA 1000000
VD 1000000
VP -4000,0
CR 1500,270,-180
VP 0,3000
CR 1500,90,-180
VE
BGS
The resulting motion starts at the point A and moves toward points B, C, D, A. Suppose that we
interrogate the controller when the motion is halfway between the points A and B.
The value of _AV is 2000
The value of _CS is 0
_VPX and _VPY contain the absolute coordinate of the point A
Suppose that the interrogation is repeated at a point, halfway between the points C and D.
The value of _AV is 4000+1500
The value of _CS is 2
_VPX,_VPY contain the coordinates of the point C
C (-4000,3000)
R = 1500
B (-4000,0)
Figure 6.3 - The Required Path

Electronic Gearing

This mode allows multiple axes to be electronically geared to some master axes. With the DMC-1415
or DMC-1416, the master is always the auxiliary encoder. With the DMC-1425, the master will be the
68 Chapter 6 Programming Motion
i
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Interpretation
Specify motion plane
Specify vector speed
Specify vector acceleration
Specify vector deceleration
Segment AB
Segment BC
Segment CD
Segment DA
End of sequence
Begin Sequence
π
+2000=10,712
D (0,3000)
A (0,0)
DMC-14x5/6