Steering; Trim Angle - TOHATSU MFS 3.5C Owner's Manual

ENOM00910-0
Spare emergency stop switch lock
A spare emergency stop switch lock is
provided in the tool bag.
When used as described, the emergency
stop switch clip and emergency stop
switch lanyard system stops the engine if
the operator falls away from the controls.
When an operator falls into water, be
sure to use emergency stop switch lock
of the spare.
Be sure to confirm the spare stop switch
lock is in the tool bag before begin to
operate.
ENOM00920-A

6. Steering

ENOW00870-0
WARNING
Sudden steering may cause passenger(s) to
be thrown overboard or falling down.
Tiller handle type
Right turn
Move the tiller handle to the left
Left turn
Move the tiller handle to the right.
ENOM00050-0

7. Trim angle

ENOW00043-A
Adjust the trim angle when the engine is
stopped.
Do not put hand or finger in between out-
ENOF00891-0
board motor body and clamp bracket
when adjusting trim angle to prevent
injury in case the outboard motor body
falls.
Unsuitable trim position can cause loss of
control of boat. When testing a trim posi-
tion, run boat slow initially to see if it can
be controlled safely.
ENOW00044-0
Excessive trim up or down may lead to unsta-
ble boat operation, potentially causing the
steering difficulty that leads to accident
during cruising.
Do not cruise at high speed if improper
trim position is suspected. Stop the boat
and readjust trim angle before continuing
cruise.
For outboard motor model with PTT
switch on the bottom cowl, do not oper-
ate the switch during cruising, or control
of boat may be lost.
ENGINE OPERATION
ENOF00892-0
WARNING
WARNING
33
7