Tabbed Inserts - Xerox DocuColor 7000 Operator's Manual

Tabbed inserts

Do c u Co lo r 80 0 0/ 70 0 0 O p er a to r Ma n ua l
Tabbed Inserts can be loaded into the paper trays as Non-
Standard paper.
• When loading, the non-tabbed, short edge of the tabbed insert
should be the lead edge to the digital press.
• If a jam occurs while running tabbed sets, there is no recovery
procedure.
• You have to manually reassemble your originals and
prints, determine where the job left off, and resume printing
or cancel the job and start again.
• The size of the tabbed insert should be 9 x 11 inch (229 x 279
mm) for letter size tabs (223.5 x 296 mm for A4 equivalent
tabs).
• The correct weight of the insert should be selected on the
tray.
• Select Non-Standard size on the paper tray and on the UI,
Tools Mode, input 11 inches or 296 mm for A4 as the X axis
and 9 inches or 223.5 mm for A4 as the Y axis dimensions for
SEF.
Refer to the System Administration Guide for the procedure to
program non-standard size paper.
2 . P ap e r a n d pa pe r t r a y s
2-9