2. P a p er an d pap e r t r ay s
Drilled paper
2- 1 0
Three-hole drilled paper can be run from all the trays either LEF or
SEF with the holes facing any direction.
NOTE: If you are stapling 3-hole drilled paper with the optional
High Capacity Stacker Stapler 80 (HCSS80), refer to the
Accessories chapter for paper loading instructions, based on the
position of the staple.
Drilled paper should be run in the Simplex (1-sided) and Duplex
(2-sided) orientations shown below to avoid paper jams caused by
the holes not aligning correctly with the paper sensor in the press.
Simplex Print Jobs
Load the drilled paper into any tray in the Long Edge Feed (LEF)
direction. Refer to the following illustration:
Duplex Print Jobs
Load drilled paper into any tray in either the Long Edge Feed
(LEF) or Short Edge Feed (SEF) direction. Refer to the following
illustration:
LEF direction
Rear of paper tray
Paper
tray
guides
Front of paper tray
NOTE: If you are stapling 3-hole drilled paper with the optional
High Capacity Stacker Stapler 80 (HCSS80), refer to the
Accessories chapter (see page 3-27 and page 3-43) for paper
loading instructions, based on the position of the staple.
Rear of paper tray
Paper
Right
side
tray
guides
Front of paper tray
Rear of paper tray
Right
side
Front of paper tray
Do c u Co l or 8 00 0 /7 00 0 O pe r a to r M a nu a l
SEF direction
Paper
tray
guides