Xerox DocuColor 7000 Operator's Manual page 132

4. P r o b le m s o l v i ng
Problem
The digital press does not
power on.
Prints are not on desired
paper size.
Paper is misfed or wrinkles
repeatedly.
4- 2
• Ensure the power cord is plugged into the receptacle correctly.
• Ensure the power switch inside the front left door is set to the ON
position.
• Check the GFI circuit breakers.
• If the power in your location is working properly, you have tried the
suggested solutions, and the digital press does not power on, call for
assistance.
• Ensure that the proper paper is loaded in the paper trays.
• Select the paper size, tray and weight through the digital press options
on your PC.
• Ensure that the correct weight is selected on the tray.
• Ensure that "Fit to Paper" or an equivalent selection is not selected in
your print driver.
• If a message appears on the UI, follow the instructions displayed and
refer to the information in this chapter.
• Ensure the proper paper (refer to the Paper chapter of this manual
and The Recommended Materials List) is loaded correctly and not
filled above the MAX line.
• Turn the paper stack around and/or over in the selected paper tray.
• Remove a few sheets from the top and the bottom of the stack in the
paper tray.
• Fan all four edges of the paper in the selected paper tray.
• Replace the paper in the selected paper tray with paper from a new
package.
• Remove any partially fed paper from the trays.
• Ensure the paper you are using had been stored properly.
Suggested solutions
Do c u Co l or 8 00 0 /7 00 0 O pe r a to r M a nu a l