Programming The Paper Supply For Tray 5 (Bypass) - Xerox DocuColor 1632 User Manual

U G ( C
S E R U I D E O P I E R
1 – 3 4
)

Programming the Paper Supply for Tray 5 (Bypass)

You must select the paper size and paper type when loading
paper into Tray 5 (Bypass). Auto Size Detect can be used with
standard size paper.
1
On the Basic Copying tab select More... under Paper Supply.
2
Select Tray 5 (Bypass) to display the Tray 5 (Bypass) screen.
3
Perform one of the following to select Paper Size:
• Select Auto Size Detect.
• Select Standard Size.
• Select the paper size from the list. Use the up and down
arrows to see more selections.
• Select Non-standard Size and enter in the X (width) and Y
(length) dimensions by using the arrows.
• Press the left or right arrows to decrease or increase the X
dimension (140-483mm).
• Press the up or down arrows to increase or decrease the Y
dimension (100-305mm).
4
Select the appropriate Paper Type using the up and down arrow
buttons. You can select Plain, Bond, Recycled, Transparency, and
Lightweight - Extra Heavyweight paper.
5
Select Save to return to the Paper Supply screen.
6
Select Start to make copies or Save to select additional features.
NOTE:Paper Tray 5 cannot be used with the following features:
Auto Size Detect with 1 to 2-Sided and 2 to 2-Sided, Auto
Reduction/Enlargement, Auto Center, Corner Shift, Negative
Image, Mirror Image, Book Duplex, Booklet Creation, Multiple Up,
Repeat Image, Bound Originals and Poster.